SECTION 45: CABIN DOORS & TRANSPARENCIES: Difference between revisions

SECTION 45: CABIN DOORS & TRANSPARENCIES (view source)

242 bytes added , 16 August

m

3,763

edits

@@ Line 57: / Line 57: @@
 * The plans provide instructions for fitting the hinges to the LHS door, and Step 3 provides the positions for the WD-1019-L and WD-1019-R hinges. The plans then instruct the builder to 'repeat this step for the right side door hinges'. Note: the WD-1019-L hinges must be placed on the left side, "-R" on the right side if you stand in front of each door and look at it.
 * A [[3D-Printed Tools and Parts|3D printable Aalignment jig]] is available to use in lieu of three scrap aluminum spacers.
-* More than one  AN960-10 washer will likely be required on some of the screws in order to get them to tighten up. Add more washers as needed. <br>[[File:WD-1019-L-R Hinges.jpg|300px|Cabin door hinge placement]]<br>See also section 4:<br>[[File:Screen_Shot_2024-04-03_at_8.29.19_AM.png|500px]]
+* More than one  AN960-10 washer will likely be required on some of the screws in order to get them to tighten up. Add more washers as needed.
+* Check that the top edge of the door is flush with the cabin top and add shims underneath the door side hinge tab if you need to raise the door. For example, the rear hinge might need a 0.080", and the forward hinge might need a 0.060 shim.<br>[[File:WD-1019-L-R Hinges.jpg|300px|Cabin door hinge placement]]<br>See also section 4:<br>[[File:Screen_Shot_2024-04-03_at_8.29.19_AM.png|500px]]
 == 45-08 ==