SECTION 46: ENGINE MOUNT & LANDING GEAR: Difference between revisions

SECTION 46: ENGINE MOUNT & LANDING GEAR (view source)

136 bytes added , 3 June

m

3,763

edits

@@ Line 31: / Line 31: @@
 ====Page 46-06====
 *Don't forget to grease the bushings on their outside.
-* Tighten to castle nuts to spec, the bushing itself must not rotate. Check that the parts riding on the outside of the bushings still rotate after torquing the castle nuts. If not, see figure 1, it says to remove some of the powder coating if necessary.
+* Tighten the castle nuts to spec, the bushing itself must not rotate. Check that the parts riding on the outside of the bushings still rotate after torquing the castle nuts. If not, see figure 1, it says to remove some of the powder coating if necessary.
+* Check for any play in the horizontal bolt / bushing setup, also see this [https://www.facebook.com/reel/1723270615230761 FB thread].
 [[Category:Hints]]