3,777
edits
SECTION 39: CONTROL SYSTEM: Difference between revisions
Jump to navigation
Jump to search
m
no edit summary
mNo edit summary |
|||
| (One intermediate revision by the same user not shown) | |||
| Line 34: | Line 34: | ||
==== Page 39-2 ==== | ==== Page 39-2 ==== | ||
* Step 3: If you have issues printing the document to scale, try printing this file instead:[[ | * Step 3: If you have issues printing the document to scale, try printing this file instead:[[Media:Pushrodholes.pdf|Pushrodholes.pdf]] | ||
** Note: HP laser printer drivers on Mac laptops may not print at the needed 1:1 scale, no matter what software you use or what you do in the print settings. Exact same file, printer and Adobe Reader are able to print at 1:1 scale on a Windows laptop. There might be an issue on Macs. | ** Note: HP laser printer drivers on Mac laptops may not print at the needed 1:1 scale, no matter what software you use or what you do in the print settings. Exact same file, printer and Adobe Reader are able to print at 1:1 scale on a Windows laptop. There might be an issue on Macs. | ||
** Hint for Onshape users: You can import a pdf page via Inkscape. Import the pdf page in Inkscape and save it out as dxf v14 file. Import that dxf file into Onshape. Start a new sketch. Add the dxf drawing to the sketch. Take a known distance between two points and call out a dimension between them. It will show the distance as it imported the drawing. You can now override that distance to the known distance and the whole dxf is now at scale. You can now overlay your own drawing while the endpoints will snap to the dxf points. Next, create a drawing within Onshape and add the sketch. You can then export that drawing back to a pdf and the scale is correct. | ** Hint for Onshape users: You can import a pdf page via Inkscape. Import the pdf page in Inkscape and save it out as dxf v14 file. Import that dxf file into Onshape. Start a new sketch. Add the dxf drawing to the sketch. Take a known distance between two points and call out a dimension between them. It will show the distance as it imported the drawing. You can now override that distance to the known distance and the whole dxf is now at scale. You can now overlay your own drawing while the endpoints will snap to the dxf points. Next, create a drawing within Onshape and add the sketch. You can then export that drawing back to a pdf and the scale is correct. | ||
| Line 72: | Line 72: | ||
** Consider adding grease between the brass bushing and the WD-1011 | ** Consider adding grease between the brass bushing and the WD-1011 | ||
** It's OK if the AN4 bolt is a bit loose inside of the brass bushing, but you need to properly tighten the nut on the AN4 bolt. It should be torqued to spec but without distorting the steel parts. The brass bushing should be firmly situated by the AN4 bolt and should not be able to rotate. | ** It's OK if the AN4 bolt is a bit loose inside of the brass bushing, but you need to properly tighten the nut on the AN4 bolt. It should be torqued to spec but without distorting the steel parts. The brass bushing should be firmly situated by the AN4 bolt and should not be able to rotate. | ||
* Step 3: Insert the bolts that hold the aileron pushrods from front to back to avoid binding with the F-1033 Control Column Mounts. [[ | * Step 3: Insert the bolts that hold the aileron pushrods from front to back to avoid binding with the F-1033 Control Column Mounts. | ||
[[Category:Hints]]. | |||