SECTION 40: FLAP SYSTEM: Difference between revisions

SECTION 40: FLAP SYSTEM (view source)

125 bytes removed , 20 December 2024

9

edits

@@ Line 14: / Line 14: @@
 ==== Page 40-5 ====
-* Alternate way to install the torque tubes: instead of inserting the torque tubes like Figure 1 on page 40-5, instead slightly enlarge the holes in the wing roots so you can insert the torque tubes from the outside. Put both torque tubes in the freezer for about four hours. Then put the UHMW plastic blocks in the oven at 120 degrees F for about thirty minutes. Google says they can withstand up to 180 degrees. This made is SUPER easy to slide everything in. The tolerances losen up considerably between the plastic blocks and the steel tubes. Don't forget the central flap crank and make sure to position the UHMW plastic blocks before everything warms up.
+* Alternate way to install the torque tubes: instead of inserting the torque tubes like Figure 1 on page 40-5, instead slightly enlarge the holes in the wing roots so you can insert the torque tubes from the outside. Put both torque tubes in the freezer for about four hours.  This mades it easy to slide the plastic bushings in place. The tolerances loosen up considerably between the plastic blocks and the steel tubes. Don't forget the central flap crank and make sure to position the UHMW plastic blocks before everything warms up.
 ==== Page 40-6 ====