3,763
edits
Hints for installing TS Flightline hoses: Difference between revisions
Hints for installing TS Flightline hoses (view source)
Revision as of 01:34, 22 January 2024
, 22 January 2024no edit summary
mNo edit summary Tags: Mobile edit Mobile web edit |
mNo edit summary Tags: Mobile edit Mobile web edit |
||
| Line 25: | Line 25: | ||
* For SDS installations, a second hole for an additional 90 degree fitting needs to be drilled into the side skin with a step drill. The location is specified in the premade fuel line manual (1 1/4 rear of rivet line, 1 1/2 inches up from side skin straight lower edge. The diameter is smaller than the existing hole, just large enough to hold the #6 fitting (9/16). This fitting needs a washer to increase the thickness. Consider using aluminum "AN SPACER, 6D" from Vans (needs to be trimmed a bit because there is a bend close-by. | * For SDS installations, a second hole for an additional 90 degree fitting needs to be drilled into the side skin with a step drill. The location is specified in the premade fuel line manual (1 1/4 rear of rivet line, 1 1/2 inches up from side skin straight lower edge. The diameter is smaller than the existing hole, just large enough to hold the #6 fitting (9/16). This fitting needs a washer to increase the thickness. Consider using aluminum "AN SPACER, 6D" from Vans (needs to be trimmed a bit because there is a bend close-by. | ||
* Consider fluting and riveting F-1099G to the side skin before installing the fuel fittings and under-seat hoses as the full rivets will be hard to buck with the fuel system installed. | * Consider fluting and riveting F-1099G to the side skin before installing the fuel fittings and under-seat hoses as the full rivets will be hard to buck with the fuel system installed. | ||
* For routing the return line over the SDS pumps, consider replacing the two right AN3 bolts with two AN3-17 bolts, two 1.16” high #12 bored standoffs and two #7 Adel clamps. | |||
==== Brake Lines ==== | ==== Brake Lines ==== | ||