3,763
edits
Hints for installing TS Flightline hoses: Difference between revisions
Hints for installing TS Flightline hoses (view source)
Revision as of 14:37, 7 January 2024
, 7 January 2024→Brake Lines
m (→Fuel Lines) |
m (→Brake Lines) |
||
| Line 30: | Line 30: | ||
* The brake line with the 90 degree fitting goes to the left side of the T-fitting that is attached to the brake fluid reservoir (copilot left pedal). | * The brake line with the 90 degree fitting goes to the left side of the T-fitting that is attached to the brake fluid reservoir (copilot left pedal). | ||
* The brake lines under the seats are going to the aftmost hole instead of the center hole if you need a return line. | * The brake lines under the seats are going to the aftmost hole instead of the center hole if you need a return line. | ||
* The brake lines under the seats are held by F-1084A/F-1084B. Normally the metal lines are protected by plastic bushings with .25 ID / .375 OD. For the premade | * The brake lines under the seats are held by F-1084A/F-1084B. Normally the metal lines are protected by plastic bushings with .25 ID / .375 OD. For the premade hoses, one can use rubber grommets forced over the fitting with a bit of heat, e.g. ID 0.375 (3/8), OD .469 (15/32). This requires enlarging the rear F-1084 holes on both sides to 15/32. Make sure the F-1084B top part is on in the right orientation as it is not symmetrical. | ||
[[Category:Optional]] | [[Category:Optional]] | ||