3,777
edits
SECTION 26: MID FUSE RIBS & BOTTOM SKINS: Difference between revisions
SECTION 26: MID FUSE RIBS & BOTTOM SKINS (view source)
Revision as of 01:04, 6 April 2023
, 6 April 2023→PAGE 26-3
m (→PAGE 26-5) |
m (→PAGE 26-3) |
||
| Line 4: | Line 4: | ||
Check for more recent updates [https://www.vansaircraft.com/service-information-and-revisions/?aircraft=rv-10&doctype=revisions-changes&sort=date here] | Check for more recent updates [https://www.vansaircraft.com/service-information-and-revisions/?aircraft=rv-10&doctype=revisions-changes&sort=date here] | ||
==PAGE 26-2 == | |||
* New Flap Motor Variant | |||
The forward edges of the F-1066C-2-L and F-1066C-2-R reinforcement angles are not flush with the forward edge of the seatbelt attach bar horizontal extension, rather they hang over a bit. They would sit flush if left and right angles were switched, however the plans say otherwise. | |||
==PAGE 26-3 == | ==PAGE 26-3 == | ||
If you have part F-1016D (seatbelt strap) with an extra tab on the side and two additional holes but your manual depicts that part without flanges/extra holes, you are experiencing the transition from the old flap motor to the new flap motor where the tab is no longer needed. Your manual is a new version but Vans sent you the older part with the tab. According to Vans, just remove the tab and match drill the two extra holes and use same rivets as the other surrounding holes. For details, see this FB thread [https://www.facebook.com/groups/vansrv10/posts/4880956025358791/ (FB Link 3/28/2022]) and [https://www.facebook.com/groups/vansrv10/posts/4891736740947386/ (FB Link 4/1/2022])<br>'''If your plans don't match what you have, check the electronic version of the plans which should show up under your name in the vans store. | If you have part F-1016D (seatbelt strap) with an extra tab on the side and two additional holes but your manual depicts that part without flanges/extra holes, you are experiencing the transition from the old flap motor to the new flap motor where the tab is no longer needed. Your manual is a new version but Vans sent you the older part with the tab. According to Vans, just remove the tab and match drill the two extra holes and use same rivets as the other surrounding holes. For details, see this FB thread [https://www.facebook.com/groups/vansrv10/posts/4880956025358791/ (FB Link 3/28/2022]) and [https://www.facebook.com/groups/vansrv10/posts/4891736740947386/ (FB Link 4/1/2022])<br>'''If your plans don't match what you have, check the electronic version of the plans which should show up under your name in the vans store. | ||