3,777
edits
SECTION 26: MID FUSE RIBS & BOTTOM SKINS: Difference between revisions
Jump to navigation
Jump to search
SECTION 26: MID FUSE RIBS & BOTTOM SKINS (view source)
Revision as of 05:33, 24 March 2023
, 24 March 2023→PAGE 26-5
m (→PAGE 26-5) |
m (→PAGE 26-5) |
||
| Line 15: | Line 15: | ||
==PAGE 26-5 == | ==PAGE 26-5 == | ||
Note that the F-1015A-R/L seat ribs have a joggle joint on the front edge with the F-1004D-L/R bulkhead where the rib will be on the inside of the outer flange of the bulkhead. Similarly, the upper portion of the front edge of the F-1018-R/L rib goes inside of the F-1005C-L/R bulkhead however, its lower part goes outside of 1005C. | Note that the F-1015A-R/L seat ribs have a joggle joint on the front edge with the F-1004D-L/R bulkhead where the rib will be on the inside of the outer flange of the bulkhead. Similarly, the upper portion of the front edge of the F-1018-R/L rib goes inside of the F-1005C-L/R bulkhead however, its lower part goes outside of F-1005C-L/R. | ||
Consider at this point whether you need access holes in the F-1017 under-seat ribs for conduit and/or antenna wiring. Many builders cut holes in the F-1017 ribs for conduit passthroughs. These holes will be much easier to cut at this point. | Consider at this point whether you need access holes in the F-1017 under-seat ribs for conduit and/or antenna wiring. Many builders cut holes in the F-1017 ribs for conduit passthroughs. These holes will be much easier to cut at this point. | ||