3,788
edits
SECTION 22: FLAP: Difference between revisions
Jump to navigation
Jump to search
m
no edit summary
m (→General) |
mNo edit summary |
||
| Line 7: | Line 7: | ||
** There are two skins that have 2 holes on the long edge about in the middle closer together. Those are the top skins. They have the same shape and same holes, but are still not quite identical as the punch direction of the holes is opposite. Probably better to put the side with the burs on the insides, then dimpling will just pronounce the punch deformation more. | ** There are two skins that have 2 holes on the long edge about in the middle closer together. Those are the top skins. They have the same shape and same holes, but are still not quite identical as the punch direction of the holes is opposite. Probably better to put the side with the burs on the insides, then dimpling will just pronounce the punch deformation more. | ||
** The remaining two skins are the bottom skins, do same selection for left / right wing by looking for the burs and keep them on the inside. | ** The remaining two skins are the bottom skins, do same selection for left / right wing by looking for the burs and keep them on the inside. | ||
==== Page 22-2 ==== | |||
* Step 3<br>If 1/4 inch brings the holes too close to the joggle, consider using a tiny bit less edge distance. There needs to be enough room for a 3/32 rivet head. Also the counter sink tool may touch the joggle's slope if the hole is tool far in. | |||
==== Page 22-5 ==== | ==== Page 22-5 ==== | ||