3,777
edits
Aerosport Hints: Difference between revisions
Jump to navigation
Jump to search
m
→Overhead Console
| Line 28: | Line 28: | ||
* [https://www.facebook.com/groups/vansrv10/posts/9815971658523845 FB Thread] 6/2025 on installation | * [https://www.facebook.com/groups/vansrv10/posts/9815971658523845 FB Thread] 6/2025 on installation | ||
* If you attach the console to the cabin top prior to installing the cabin top, it is easier, but you'll also cover up a handful of the rivet holes at the aft top center of the cabin top. With careful alignment of the overhead console and some trimming of the aft flanges you can have enough room to get a pop rivet into every hole that is under the cabin top. | * If you attach the console to the cabin top prior to installing the cabin top, it is easier, but you'll also cover up a handful of the rivet holes at the aft top center of the cabin top. With careful alignment of the overhead console and some trimming of the aft flanges you can have enough room to get a pop rivet into every hole that is under the cabin top. | ||
* You need to match drill the door strut attach brackets to the canopy before attaching the overhead panel. This may also involve notching the overhead panel for the bracket. | |||
* If you have a BRS parachute, don't install the overhead console early. You first need to install the cabin top, then the top skin, then the BRS gussets, then the overhead console. | * If you have a BRS parachute, don't install the overhead console early. You first need to install the cabin top, then the top skin, then the BRS gussets, then the overhead console. | ||
[[File:2025-03-18 16.54.47.jpg|thumb|Overhead console after being attached to cabin top with epoxy. Fiberglass over the flanges. The rear flanges are not particularly finished because they will be covered by headliner. The front has nutplates and a wiring hole for the overhead switch module.]] | [[File:2025-03-18 16.54.47.jpg|thumb|Overhead console after being attached to cabin top with epoxy. Fiberglass over the flanges. The rear flanges are not particularly finished because they will be covered by headliner. The front has nutplates and a wiring hole for the overhead switch module.]] | ||