25
edits
SECTION 26: MID FUSE RIBS & BOTTOM SKINS: Difference between revisions
Jump to navigation
Jump to search
→PAGE 26-5
| Line 30: | Line 30: | ||
====PAGE 26-5 ==== | ====PAGE 26-5 ==== | ||
Unless otherwise specified by Vans, all rivets should have their machine heads to the inside of the foot well. That is, the machine heads should be on the F- | Unless otherwise specified by Vans, all rivets should have their machine heads to the inside of the foot well. That is, the machine heads should be on the F-1017A rib side. This will aid the installation of the floor pan on page 35-2. | ||
Step 5: it doesn't explicitly say anything about fluting the F-1018-L and F-1018-R ribs. Even if it did, I might have assumed if it was straight it was good. Well, it turns out that it needs to not be straight to match the holes in the bottom skin. It is a real pain to try to flute it later. | Step 5: it doesn't explicitly say anything about fluting the F-1018-L and F-1018-R ribs. Even if it did, I might have assumed if it was straight it was good. Well, it turns out that it needs to not be straight to match the holes in the bottom skin. It is a real pain to try to flute it later. | ||