Aerosport Hints: Difference between revisions

Aerosport Hints (view source)

142 bytes removed , 26 March

186

edits

@@ Line 25: / Line 25: @@
 * [https://www.facebook.com/groups/vansrv10/posts/7251416044979432 FB Thread on adhesive 4/2024]
 * [https://www.facebook.com/groups/vansrv10/posts/7927760794011617 FB Thread on interference with rear bulkhead 8/2024]
-* If you attach the console to the cabin top prior to installing the cabin top, it is easier, but you'll also cover up a handful of the rivet holes at the aft top center of the cabin top. That means you'll need to use pop rivets for these as part of the cabin top install (when you rivet from the aft top skin into the cabin top). With careful alignment of the overhead console and some trimming of the aft flanges you can have enough room to get a pop rivet into every hole that is under the cabin top.
+* If you attach the console to the cabin top prior to installing the cabin top, it is easier, but you'll also cover up a handful of the rivet holes at the aft top center of the cabin top.  With careful alignment of the overhead console and some trimming of the aft flanges you can have enough room to get a pop rivet into every hole that is under the cabin top.
 [[File:2025-03-18 16.54.47.jpg|thumb|Overhead console after being attached to cabin top with epoxy. Fiberglass over the flanges. The rear flanges are not particularly finished because they will be covered by headliner. The front has nutplates and a wiring hole for the overhead switch module.]]