186
edits
Aerosport Hints: Difference between revisions
→Overhead Console: Added photo of overhead console preparation.
(→Panel) |
(→Overhead Console: Added photo of overhead console preparation.) |
||
| Line 21: | Line 21: | ||
* [https://www.facebook.com/groups/vansrv10/posts/7251416044979432 FB Thread on adhesive 4/2024] | * [https://www.facebook.com/groups/vansrv10/posts/7251416044979432 FB Thread on adhesive 4/2024] | ||
* [https://www.facebook.com/groups/vansrv10/posts/7927760794011617 FB Thread on interference with rear bulkhead 8/2024] | * [https://www.facebook.com/groups/vansrv10/posts/7927760794011617 FB Thread on interference with rear bulkhead 8/2024] | ||
* If you attach the console to the cabin top prior to installing the cabin top, it is easier, but you'll also cover up a handful of the rivet holes at the aft top center of the cabin top. That means you'll need to use pop rivets for these as part of the cabin top install (when you rivet from the aft top skin into the cabin top). With careful alignment of the overhead console and some trimming of the aft flanges you can have enough room to get a pop rivet into every hole that is under the cabin top. | |||
[[File:2025-03-18 16.54.47.jpg|thumb|Overhead console after being attached to cabin top with epoxy. Fiberglass over the flanges. The rear flanges are not particularly finished because they will be covered by headliner. The front has nutplates and a wiring hole for the overhead switch module.]] | |||
==== Carpet ==== | ==== Carpet ==== | ||
| Line 61: | Line 63: | ||
***Drill a 7/64 hole for the slotted spring pin through the valve end of the extension using the two holes of the valve fitting as a guide. Insert the pin with a hammer to secure the extension to the valve. | ***Drill a 7/64 hole for the slotted spring pin through the valve end of the extension using the two holes of the valve fitting as a guide. Insert the pin with a hammer to secure the extension to the valve. | ||
[[Category:Optional]] | [[index.php?title=Category:Optional]] | ||