186
edits
SECTION 25: MID FUSE BULKHEADS: Difference between revisions
Jump to navigation
Jump to search
SECTION 25: MID FUSE BULKHEADS (view source)
Revision as of 12:46, 4 September 2024
, 4 September 2024Added tip for page 25-8
m (→PAGE 25-5) |
(Added tip for page 25-8) |
||
| Line 43: | Line 43: | ||
==PAGE 25-8== | ==PAGE 25-8== | ||
I am still unable to interpret Figure 1 -- is the part shown concave or convex? I'm not sure. But F-1034D-L and F-1034D-R are definitely different. I thought I had it right, I riveted on this page, and I didn't notice I had them backwards until the end of Section 26. I found that my F-1034C-L and F-1034C-R were angled outboard and they should be more or less perpendicular to F-1034A. I don't see a downside to leaving these cleco'd and riveting in section 26. | |||
* Enlarge the two holes at the lower corners of F-1034A to a bit larger than .75 inches (.77) so they can pass through Van's conduit later | * Enlarge the two holes at the lower corners of F-1034A to a bit larger than .75 inches (.77) so they can pass through Van's conduit later | ||
[[Category:Hints]] | [[Category:Hints]] | ||