6
edits
SECTION 7: RUDDER: Difference between revisions
→Page 7-6 Step 11
No edit summary |
FFooccuuss (talk | contribs) |
||
| Line 23: | Line 23: | ||
*[https://www.youtube.com/watch?v=mk9ueCr89FU 7-9, step 2-8] | *[https://www.youtube.com/watch?v=mk9ueCr89FU 7-9, step 2-8] | ||
*[https://www.youtube.com/watch?v=BU2pugfaLro 7-10 to 7-12] | *[https://www.youtube.com/watch?v=BU2pugfaLro 7-10 to 7-12] | ||
==== Page 7-4 Step 2 ==== | |||
If your microstop (countersink) cage interferes with the radius of the R-1005 Rudder Horn on the 2nd set of countersink holes, one solution is to use a shim between the microstop cage and the part. I used a stepped drill bit (unibit) to put a 5/16" hole in a large popsicle stick that measured .060" thick. If you set the perfect depth of the microstop on the previous two holes, then .060" is exactly two full turns clockwise to account for the thickness of the popsicle shim. Don't forget to reset the depth of the cage afterwards! | |||
[[File:PXL 20240422 195058219.jpg|none|thumb|Countersink shim for R-1005 Rudder Horn]] | |||
[[File:PXL 20240422 195204750-crop.jpg|none|thumb|Countersink shim stack-up with rudder horn]] | |||
==== Page 7-6 Step 11 ==== | ==== Page 7-6 Step 11 ==== | ||
| Line 60: | Line 65: | ||
I recommend using a piece of wood on the outside to simply press against the skin to bend it until it gets fairly flush. Then you can hammer against that outside piece of wood to make it even flatter. Finally, you can use your rivet gun with the flat mushroom set on VERY LOW power to make the seam nice and defined. Absolutely make sure you have wood (not metal) on the back side of the skin (just as specified in the instructions). | I recommend using a piece of wood on the outside to simply press against the skin to bend it until it gets fairly flush. Then you can hammer against that outside piece of wood to make it even flatter. Finally, you can use your rivet gun with the flat mushroom set on VERY LOW power to make the seam nice and defined. Absolutely make sure you have wood (not metal) on the back side of the skin (just as specified in the instructions). | ||
[[Category:Hints]] | [[index.php?title=Category:Hints]] | ||