SECTION 32: TAILCONE ATTACHMENT: Difference between revisions

SECTION 32: TAILCONE ATTACHMENT (view source)

106 bytes added , 22 February 2024

m

3,777

edits

@@ Line 46: / Line 46: @@
 *Step 6 refers to "Page 33-4, Figure 3", correct is "Page 32-4, Figure 3". Also, debur the 6 holes before dimpling as they were recently match drilled.
 * Step 18, installing two SB625-7 snap bushings: those shipped with the empennage kit, not part of the fuselage kit / fuselage QB kit.<br>Don't install any of the snap bushings yet that carry the rudder cable. You cannot get the rudder cable end fitting through the snap bushings if they are mounted as they need to be squeezed oval to let them through. Install the snap bushings along with the rudder cable install instructions on page 38-8.
-*Once you are done with the tailcone attach, add two AN960-8 washers and AN515-8R8 screws to the frontmost two holes of the F-1035 battery mount. The nutplates are now installed. The build instructions don't cover those two holes.
+*Once you are done with the tailcone attach, add two AN960-8 washers and AN515-8R8 screws to the frontmost two holes of the F-1035 battery mount. The nutplates are now installed. The build instructions don't cover those two holes. Note: You will later remove the entire F-1035 battery mount to thread in both forward elevator push rods.
 [[Category:Hints]]