3,777
edits
Hints for installing TS Flightline hoses: Difference between revisions
Hints for installing TS Flightline hoses (view source)
Revision as of 21:08, 21 January 2024
, 21 January 2024→Fuel Lines
m (→Fuel Lines) |
m (→Fuel Lines) Tags: Mobile edit Mobile web edit |
||
| Line 17: | Line 17: | ||
** 9 Pump to firewall | ** 9 Pump to firewall | ||
** 10 fuel return line | ** 10 fuel return line | ||
** | ** ASH103-10 R1 H11 and H12 - fuel lines valve to rib fitting | ||
* If you have the setup for SDS fuel pumps, consider not running the hose from the fuel valve to the pumps in a straight line. The hose is very short and stiff and has no way to shrink / stretch if there is no bend in it. It also gives you a bit more freedom concerning how far to screw the fitting into the pump assembly. The milled distribution manifold may not allow you to add another full turn.<br>[[File:2023-09-04 14-32-38.jpg|467x467px]] | * If you have the setup for SDS fuel pumps, consider not running the hose from the fuel valve to the pumps in a straight line. The hose is very short and stiff and has no way to shrink / stretch if there is no bend in it. It also gives you a bit more freedom concerning how far to screw the fitting into the pump assembly. The milled distribution manifold may not allow you to add another full turn.<br>[[File:2023-09-04 14-32-38.jpg|467x467px]] | ||
* The fuel line(s) under the seats are held by F-1084A/F-1084B. Normally the metal lines are protected by plastic bushings with 0.375 ID / 0.5 OD. For the premade hoses, one can use rubber grommets forced over the fitting with a bit of heat, e.g. ID 0.5 (1/2), OD .594 (19/32). This requires enlarging the two forward F-1084 holes to 19/32 (two for SDS installations). Make sure the F-1084B top part is on in the right orientation as it is not symmetrical. | * The fuel line(s) under the seats are held by F-1084A/F-1084B. Normally the metal lines are protected by plastic bushings with 0.375 ID / 0.5 OD. For the premade hoses, one can use rubber grommets forced over the fitting with a bit of heat, e.g. ID 0.5 (1/2), OD .594 (19/32). This requires enlarging the two forward F-1084 holes to 19/32 (two for SDS installations). Make sure the F-1084B top part is on in the right orientation as it is not symmetrical. | ||