3,777
edits
Aerosport Hints: Difference between revisions
m
→Armrest with Throttle Quadrant
| Line 14: | Line 14: | ||
** [https://www.homedepot.com/p/Dremel-1-1-4-in-Rotary-Tool-Carbide-Cutting-Shaping-Wheel-for-Use-on-Woods-Fiberglass-Plastics-and-Laminates-543/202315728 Dremel Cutting / Shaping Wheel] | ** [https://www.homedepot.com/p/Dremel-1-1-4-in-Rotary-Tool-Carbide-Cutting-Shaping-Wheel-for-Use-on-Woods-Fiberglass-Plastics-and-Laminates-543/202315728 Dremel Cutting / Shaping Wheel] | ||
* Hints | * Hints | ||
** Don't dimple #8 the tunnel cover holes in the area where the armrest will sit. | ** Don't dimple #8 the tunnel cover side holes in the area where the armrest will sit. | ||
** The friction lock hole in the carbon fiber on the side needs to be large enough for the black tensioner stem to fit through and sit against the throttle quadrant, not pinch the carbon fiber. | ** The friction lock hole in the carbon fiber on the side needs to be large enough for the black tensioner stem to fit through and sit against the throttle quadrant, not pinch the carbon fiber. | ||
** Consider adding washers to the throttle handle bolt on both sides as the machined part is very thin just around the holes (Holes were made with a drill bit rather than with a router bit). | ** Consider adding washers to the throttle handle bolt on both sides as the machined part is very thin just around the holes (Holes were made with a drill bit rather than with a router bit). | ||