3,777
edits
BRS Installation Hints: Difference between revisions
Jump to navigation
Jump to search
m
→Parachute Canister
| Line 44: | Line 44: | ||
*Watch out for the inboard flange of the canister. It's not possible to position the box avoiding having to drill into the radius of the tunnel rib. Consider relocating one of the screw holes and omitting the furthest aft hole.<br>[[File:2023-05-21 17-35-25.jpg|400x400px]]<br>[[File:342978863 1188901461796912 5224335669764995450 n.jpg|400x400px]] | *Watch out for the inboard flange of the canister. It's not possible to position the box avoiding having to drill into the radius of the tunnel rib. Consider relocating one of the screw holes and omitting the furthest aft hole.<br>[[File:2023-05-21 17-35-25.jpg|400x400px]]<br>[[File:342978863 1188901461796912 5224335669764995450 n.jpg|400x400px]] | ||
*Trim the inside canister flange along the tunnel cover to allow mounting it without interference.<br>[[File:2023-06-10 13-20-54.jpg|400x400px]]<br>[[File:2023-06-10 13-51-49.jpg|400x400px]] | *Trim the inside canister flange along the tunnel cover to allow mounting it without interference.<br>[[File:2023-06-10 13-20-54.jpg|400x400px]]<br>[[File:2023-06-10 13-51-49.jpg|400x400px]] | ||
*Consider adding a 7 inch long angle bracket to the baggage floor rib to provide good support for | *Consider adding a 7 inch long angle bracket to the baggage floor rib to provide good support for 3 newly located rear flange holes (picture has one hole with edge distance issues, move it more towards the rib).<br>[[File:2023-06-10 16-06-41.jpg|400x400px]] | ||
*Easiest way to do the cut-outs is to do a rough cut using a nibbler or saw, then do a precise cut to the line using aviation snips.<br>[[File:2023-06-03 16-33-03.jpg|533x533px]] | *Easiest way to do the cut-outs is to do a rough cut using a nibbler or saw, then do a precise cut to the line using aviation snips.<br>[[File:2023-06-03 16-33-03.jpg|533x533px]] | ||
*After cutting out the luggage floor rectangle, consider removing the short remnants of the stiffeners that are each held by just one rivet (already removed at the bottom of this image). Round off the two remaining stiffeners towards the cut-out.<br>[[File:2023-05-28 17-56-07.jpg|400x400px]] | *After cutting out the luggage floor rectangle, consider removing the short remnants of the stiffeners that are each held by just one rivet (already removed at the bottom of this image). Round off the two remaining stiffeners towards the cut-out.<br>[[File:2023-05-28 17-56-07.jpg|400x400px]] | ||