3,777
edits
SECTION 46: ENGINE MOUNT & LANDING GEAR: Difference between revisions
SECTION 46: ENGINE MOUNT & LANDING GEAR (view source)
Revision as of 03:48, 29 April 2023
, 29 April 2023→Page 46-02
m (→Page 46-02) |
m (→Page 46-02) |
||
| Line 20: | Line 20: | ||
** 23/64 (0.359375) | ** 23/64 (0.359375) | ||
** 3/8 reamer (0.375), e.g. [https://www.amazon.com/dp/B076DMH4BF at Amazon] | ** 3/8 reamer (0.375), e.g. [https://www.amazon.com/dp/B076DMH4BF at Amazon] | ||
* Note: Don't waste the single-use metal stop nuts yet, instead use AN6 castle nuts or 3/8-24 hardware store nuts for the drill process. | |||
====Page 46-06==== | ====Page 46-06==== | ||
*Don't forget to grease the bushings on their outside. | *Don't forget to grease the bushings on their outside. | ||
* Tighten to castle nuts to spec, the bushing itself must not rotate. Check that the parts riding on the outside of the bushings still rotate after torquing the castle nuts. If not, see figure 1, it says to remove some of the powder coating if necessary. | * Tighten to castle nuts to spec, the bushing itself must not rotate. Check that the parts riding on the outside of the bushings still rotate after torquing the castle nuts. If not, see figure 1, it says to remove some of the powder coating if necessary. | ||