3,777
edits
SECTION 26: MID FUSE RIBS & BOTTOM SKINS: Difference between revisions
SECTION 26: MID FUSE RIBS & BOTTOM SKINS (view source)
Revision as of 05:28, 24 March 2023
, 24 March 2023→PAGE 26-5
m (→PAGE 26-4) |
m (→PAGE 26-5) |
||
| Line 15: | Line 15: | ||
==PAGE 26-5 == | ==PAGE 26-5 == | ||
Note that the F-1015A seat rib has a joggle joint on the front edge with the F-1004D bulkhead where the rib's joggle will be on the inside of the outer flange of the bulkhead. Similarly, the upper joggle of the front edge of the 1018 rib goes inside of the 1005C bulkhead however, its lower part goes outside of 1005C. | |||
Consider at this point whether you need access holes in the F-1017 under-seat ribs for conduit and/or antenna wiring. Many builders cut holes in the F-1017 ribs for conduit passthroughs. These holes will be much easier to cut at this point. | Consider at this point whether you need access holes in the F-1017 under-seat ribs for conduit and/or antenna wiring. Many builders cut holes in the F-1017 ribs for conduit passthroughs. These holes will be much easier to cut at this point. | ||