3,777
edits
SECTION 25: MID FUSE BULKHEADS: Difference between revisions
Jump to navigation
Jump to search
SECTION 25: MID FUSE BULKHEADS (view source)
Revision as of 19:33, 24 November 2022
, 24 November 2022→PAGE 25-4
m (→PAGE 25-6) |
m (→PAGE 25-4) |
||
| Line 21: | Line 21: | ||
==PAGE 25-4== | ==PAGE 25-4== | ||
Step 6 requires you to 'Rivet the Mid Seat Rail Support Subassemblies, F-1004C-L and -R Center Section Bulkheads and F-1004N Stiffener Angles to the F-1004A Center Section Bulkhead per the callouts in Figure 2.' Figure 2 in the plans (Rev 1 Date 1/7/21) omits the quantity and rivets to be used. The older plans (Rev 0 Date 7/24/14) shows the rivets and places. | * Step 6<br> Step 6 requires you to 'Rivet the Mid Seat Rail Support Subassemblies, F-1004C-L and -R Center Section Bulkheads and F-1004N Stiffener Angles to the F-1004A Center Section Bulkhead per the callouts in Figure 2.' Figure 2 in the plans (Rev 1 Date 1/7/21) omits the quantity and rivets to be used. The older plans (Rev 0 Date 7/24/14) shows the rivets and places. | ||
* Step 7<br>Don't insert the snap bushings instead widen the two holes to a bit larger than .75 inches (but below .82) so they can pass through Van's conduit later. Also drill a third hole with same diameter underneath the two holes for a third conduit. | |||
==PAGE 25-5== | ==PAGE 25-5== | ||