3,777
edits
Airflow Systems: Difference between revisions
m
→Scoop / Condenser Mounting
m (→O-Rings) |
|||
| Line 15: | Line 15: | ||
* In order to mark the two holes for the condenser fittings one needs to make a template. A good way is to first make very large holes roughly where they need to be, then pass the fittings through those holes (make sure they are perpendicular to the condenser), then take additional snippets that have half-hole cutouts at their edges and tape them to the template so the half-holes touch the fitting. | * In order to mark the two holes for the condenser fittings one needs to make a template. A good way is to first make very large holes roughly where they need to be, then pass the fittings through those holes (make sure they are perpendicular to the condenser), then take additional snippets that have half-hole cutouts at their edges and tape them to the template so the half-holes touch the fitting. | ||
*The manual doesn't state where left and right is on the master hose plan. Since the VS/rudder isn't drawn, one might think that the plan is as seen from the bottom, however, the plan is drawn looking down on the plane. | *The manual doesn't state where left and right is on the master hose plan. Since the VS/rudder isn't drawn, one might think that the plan is as seen from the bottom, however, the plan is drawn looking down on the plane. | ||
* Check the 90-degree fittings before attaching to the condenser as there might be white powder / residue inside from the soldering process. Can be removed with a round brush and blown out with clean compressed air. | |||
===== Evaporator Shelf Mounting ===== | ===== Evaporator Shelf Mounting ===== | ||
*The evaporator shelf touches the vertical bulkhead support on its front side and sits flush against the inside edges of the longerons. The manual states that this is roughly 3 inches back from the bulkhead but it's only 2 inches<br>[[File:2022-08-14 15-11-31.jpg|400x400px]] | *The evaporator shelf touches the vertical bulkhead support on its front side and sits flush against the inside edges of the longerons. The manual states that this is roughly 3 inches back from the bulkhead but it's only 2 inches<br>[[File:2022-08-14 15-11-31.jpg|400x400px]] | ||