23
edits
SECTION 26: MID FUSE RIBS & BOTTOM SKINS: Difference between revisions
SECTION 26: MID FUSE RIBS & BOTTOM SKINS (view source)
Revision as of 05:33, 4 July 2022
, 4 July 2022→PAGE 26-3
| Line 5: | Line 5: | ||
==PAGE 26-3 == | ==PAGE 26-3 == | ||
If you have part F-1016D (seatbelt strap) with an extra tab on the side and two additional holes but your manual depicts that part without flanges/extra holes, you are experiencing the transition from the old flap motor to the new flap motor where the tab is no longer needed. Your manual is a new version but Vans sent you the older part with the tab. According to Vans, just remove the tab and match drill the two extra holes and use same rivets as the other surrounding holes. For details, see this FB thread [https://www.facebook.com/groups/vansrv10/posts/4880956025358791/ (FB Link 3/28/2022]) and [https://www.facebook.com/groups/vansrv10/posts/4891736740947386/ (FB Link 4/1/2022])<br>'''If your plans don't match what you have, check the electronic version of the plans which should show up under your name in the vans store. If for some reason, the electronic version still doesn't match what you have, try [[File:26_10.pdf]]'''. | If you have part F-1016D (seatbelt strap) with an extra tab on the side and two additional holes but your manual depicts that part without flanges/extra holes, you are experiencing the transition from the old flap motor to the new flap motor where the tab is no longer needed. Your manual is a new version but Vans sent you the older part with the tab. According to Vans, just remove the tab and match drill the two extra holes and use same rivets as the other surrounding holes. For details, see this FB thread [https://www.facebook.com/groups/vansrv10/posts/4880956025358791/ (FB Link 3/28/2022]) and [https://www.facebook.com/groups/vansrv10/posts/4891736740947386/ (FB Link 4/1/2022])<br>'''If your plans don't match what you have, check the electronic version of the plans which should show up under your name in the vans store. If for some reason, the electronic version still doesn't match what you have, try [[File:26_10.pdf]]'''. | ||
Step 6 gotcha: Plans call for 'Dimple the screw holes in the inboard flange of the seat rib intercostals that correspond to the flush nut plates...' Note that there are 3 nut plates on this flange, but only 2 of them are flush nut plates. The top nut plate is a K1000-08 and must not have its screw hole dimpled. | |||
==PAGE 26-5 == | ==PAGE 26-5 == | ||