SECTION 45: CABIN DOORS & TRANSPARENCIES

From RV10 Community Wiki
Jump to navigation Jump to search

Build Instruction Updates

Check for more recent updates here

General

  • For door options see the page Door Looks / Hinges / Handles / Seals.
  • If you are installing the PlaneAround third latch, consider installing the gearbox before bonding the inner and outer door shell, see this FB post
  • Do not clean adhesive residue off the windows with anything but mineral spirits. Do not clean with concentrated alcohol. The exact instructions can be found here.
  • Door fit: See this VAF Thread
    and this FB post
    and this FB post
    and this FB post
    and this FB post
  • Epoxy to use: See this FB Thread 3/2024
  • After trimming the windows, you might need to renew the protective wrap, consider using collision wrap.

45-02

  • The holes in the two door halves don't align, just use the ones that do align, see also this FB thread 4/2024.

45-06

  • A bolt is used as hinge pin. Consider grinding down the head a bit if it interferes with the cabin pocket.
  • A group of builders are working on a hinge cover, see OnShape CAD project, check fit using this 1:1 print pdf file
  • The plans provide instructions for fitting the hinges to the LHS door, and Step 3 provides the positions for the WD-1019-L and WD-1019-R hinges. The plans then instruct the builder to 'repeat this step for the right side door hinges'. Note: the WD-1019-L hinge must be placed Forward side, and the WD-1019-R hinge must be placed Aft side of the doors, not Left and Right as the part naming would suggest.
    Cabin door hinge placement
    See also section 4:

45-08

45-19