SECTION 12: EMPENNAGE FAIRINGS

From RV10 Community Wiki
Revision as of 00:48, 30 March 2022 by 76.176.107.19 (talk) (Created page with "== Page 12-2 == * Step 1: Good results were achieved by clamping an aluminum strip along the recess edge and then using a Dremel with router attachment to square the edge. Even though the Dremel has the potential to eat into the aluminum strip, one can guide the Dremel in a fashion where it barely touches the strip. == Page 12-3 == * It is possible to 3D-print a mold and lay up a fiberglass cap that goes onto the leading edge of E-912 instead of building it up to match...")
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to navigation Jump to search

Page 12-2

  • Step 1: Good results were achieved by clamping an aluminum strip along the recess edge and then using a Dremel with router attachment to square the edge. Even though the Dremel has the potential to eat into the aluminum strip, one can guide the Dremel in a fashion where it barely touches the strip.

Page 12-3

  • It is possible to 3D-print a mold and lay up a fiberglass cap that goes onto the leading edge of E-912 instead of building it up to match the curvature of E-913. The 3D-print project is here at Onshape.
  • It is possible to 3D-print a mold and lay up a fiberglass insert that goes into HS-910. It has the right curvature and it has the necessary curvature to match the Elevator counter weight leading edge. The 3D-print project is here at Onshape.
Retrieved from "https://rv10.org/index.php?title=SECTION_12:_EMPENNAGE_FAIRINGS&oldid=427"