25
edits
SECTION 26: MID FUSE RIBS & BOTTOM SKINS: Difference between revisions
→PAGE 26-2
| Line 15: | Line 15: | ||
* New Flap Motor Variant | * New Flap Motor Variant | ||
The forward edges of the F-1066C-2-L and F-1066C-2-R reinforcement angles are not flush with the forward edge of the seatbelt attach bar horizontal extension, rather they hang over a bit. They would sit flush if left and right angles were switched, however the plans say otherwise. | The forward edges of the F-1066C-2-L and F-1066C-2-R reinforcement angles are not flush with the forward edge of the seatbelt attach bar horizontal extension, rather they hang over a bit. They would sit flush if left and right angles were switched, however the plans say otherwise. | ||
* Unless otherwise specified by Vans, all rivets should have their machine heads to the inside of the foot well. | * Unless otherwise specified by Vans, all rivets should have their machine heads to the inside of the foot well. That is, the machine heads should be on the F-814HPP side. This will aid the installation of the floor pan on page 35-2. | ||
====PAGE 26-3 ==== | ====PAGE 26-3 ==== | ||