3,777
edits
SECTION 29: FUSE SIDE SKINS: Difference between revisions
SECTION 29: FUSE SIDE SKINS (view source)
Revision as of 23:18, 23 September 2023
, 23 September 2023→29-15
m (→29-15) |
m (→29-15) |
||
| Line 10: | Line 10: | ||
== 29-15 == | == 29-15 == | ||
* Questions on which holes to dimple? See [https://www.facebook.com/groups/vansrv10/posts/5839137336207317 this FB thread]. Another [https://www.facebook.com/groups/vansrv10/posts/6453842408070137 FB thread on same topic] | * Questions on which holes to dimple? See [https://www.facebook.com/groups/vansrv10/posts/5839137336207317 this FB thread]. Another [https://www.facebook.com/groups/vansrv10/posts/6453842408070137 FB thread on same topic] | ||
== 29-19 == | |||
* If you are using the Aerosport interior side panels, don't install the VENT-0004 knob. The Aerosport side vents need a different extension lever which can only be attached once the panel is in place. | |||
* The kit may not include the nylon washers 5610-90-31. They can be obtained at your local hardware store as #10 Nylon washer. | |||
== 29-20 == | == 29-20 == | ||
* Don't rivet the forward cabin floor to the center tunnel walls if you are getting electronic injection (SDS or EFII), or you intend to install access covers to the side of the tunnel as the rivet holes will be needed. For the SDS pump shelf, you will have 5 stock rivets counting from front, then the next 11 are to be left out for the fuel pump shelf. For the access covers, see the instructions from Airward. | * Don't rivet the forward cabin floor to the center tunnel walls if you are getting electronic injection (SDS or EFII), or you intend to install access covers to the side of the tunnel as the rivet holes will be needed. For the SDS pump shelf, you will have 5 stock rivets counting from front, then the next 11 are to be left out for the fuel pump shelf. For the access covers, see the instructions from Airward. | ||