SECTION 12: EMPENNAGE FAIRINGS: Difference between revisions
Created page with "== Page 12-2 == * Step 1: Good results were achieved by clamping an aluminum strip along the recess edge and then using a Dremel with router attachment to square the edge. Even though the Dremel has the potential to eat into the aluminum strip, one can guide the Dremel in a fashion where it barely touches the strip. == Page 12-3 == * It is possible to 3D-print a mold and lay up a fiberglass cap that goes onto the leading edge of E-912 instead of building it up to match..."
(Created page with "== Page 12-2 == * Step 1: Good results were achieved by clamping an aluminum strip along the recess edge and then using a Dremel with router attachment to square the edge. Even though the Dremel has the potential to eat into the aluminum strip, one can guide the Dremel in a fashion where it barely touches the strip. == Page 12-3 == * It is possible to 3D-print a mold and lay up a fiberglass cap that goes onto the leading edge of E-912 instead of building it up to match...") |
(No difference)
|