Page history
6 July 2025
19 April 2025
23 February 2025
11 May 2024
23 November 2023
20 March 2023
12 June 2022
30 March 2022
→Page 12-3
+1
→Page 12-3
−1
→Page 12-3
−5
→Page 12-3
→Page 12-3
+12
→Page 12-3
+149
Created page with "== Page 12-2 == * Step 1: Good results were achieved by clamping an aluminum strip along the recess edge and then using a Dremel with router attachment to square the edge. Even though the Dremel has the potential to eat into the aluminum strip, one can guide the Dremel in a fashion where it barely touches the strip. == Page 12-3 == * It is possible to 3D-print a mold and lay up a fiberglass cap that goes onto the leading edge of E-912 instead of building it up to match..."
+1,105