Tools needed to wire a Garmin panel

DMC AFM8 Crimp Tool M22520/2-01 [1]
K13-1 M22520/2-08 (Positioner for Male and Female normal density pins) [2]
K42 M22520/2-09 (Positioner for Male high density pins, Garmin does not use Female high density pins on connectors) [3]
Stripping tool for 16-26 AWG, e.g. "Stripmaster" from Ideal Ind Inc, e.g. at Amazon [4]
Pin removal tool normal density, e.g. Aiconics USA, M81969/1-02, red
Pin removal tool high density, e.g. Step N Go, M81969/1-04, green
Hex Screwdriver 3/32, at least 2 3/4 inches long, e.g. in set of article 5709A38 at https://www.mcmaster.com/
Crimp tool for coax and car connectors (ground), e.g. [5]
Coax dies for above tool, e.g. [6]
Car connector dies for above tool, e.g. [7]
Solder station, e.g. [8]
Fine tip for above solder station [9]
Digital heat gun, e.g. [10]

Solder sleeves, starter kit, e.g. this kit [11]
Solder sleeves, additional, e.g. 50 x [12]
Grounding wires, additional, e.g. [13]
Garmin suggested highest quality CAN Bus wire, e.g. [14]
Shield fasteners for Garmin connectors (not included in connector kits, except for remote COM)
- McMaster 91772A191 SS Screw
- McMaster 90107A010 SS Washer
- McMaster 92147A425 SS Split Washer
BNC antenna connector straight (G3X GPS, VHF, NAV) [15]
BNC antenna connector 90 degree (G3X GPS, VHF, NAV) [16]
TNC antenna connector straight (certified GPS) [17]
TNC antenna connector 90 degree (certified GPS) [18]

Navigation menu