QB Fuselage
Tools
- #36 drill bit to drill out 1/8 pop rivets
Links
Additional Comments
- References to "Page 28-16: Both sets of F-1057 L/R Mid-Seat Rail Supports" are outdated as newer fuselages no longer have this part.
- "Page 27-2: If going with a Lycoming engine, the three holes in the recess need to be widened to 5/8 inch with a Unibit". If you have an engine with electronic injection, you don't need the rightmost hole as there is no mixture. Dimple and close with 3/32 rivet.
- Page 29-9, step 5: Both longerons were too long (the left one will interfere with the vertical post of the baggage door, the right one will interfere with tailcone bulkhead). Mark the correct length from the last rivet, jam a piece of robust steel sheet metal between the longeron and the skin and cut the longeron with a dremel "thin cut" metal disk.