QB Fuselage

Tools

• #36 drill bit to drill out 1/8 pop rivets

Links

• Operation RV-10 (2016)
• Vansairforce Thread (2020)

Additional Comments

• References to "Page 28-16: Both sets of F-1057 L/R Mid-Seat Rail Supports" are outdated as newer fuselages no longer have this part.
• "Page 27-2: If going with a Lycoming engine, the three holes in the recess need to be widened to 5/8 inch with a Unibit". If you have an engine with electronic injection, you don't need the rightmost hole as there is no mixture. Dimple and close with 3/32 rivet.
• Page 29-9, step 5: Both longerons were too long. Mark the correct length from the last rivet, jam a piece of robust steel sheet metal between the longeron and the skin and cut the longeron with a dremel "thin cut" metal disk.