SECTION 34: BAGGAGE DOOR

Build Instruction Updates

• N/A

Check for more recent updates here

Hints

• Ed's video on how to make the door removable
  Note: you will need more hinge pin length than with the stock setup.
  
• Consider securing the ends of the pins with a safety wire. Thread the safety wire all the way over to the other end of the door and grab them through the door lock hole. Twist the ends and form the wire so it sits flush when pulling the safety wire all the way back towards the hinge. Safety wire the hinge pins.
  
  Split hinge pin with safety wires.

Page 34-6

• Step 4 - see Door_Locks_/_Hinges_/_Handles for weather strip options.
• Step 5 - You may not be able to reach the upper two rivets from the backside. Consider using two CCR-264SS-3-2 pull rivets. The AN470AD4-5 and AN470AD4-7 rivets on top are hard to reach, consider using pull rivets (Note: LP4-3s are not long enough to replace a 4-7) or use full rivets and a 12 inch back rivet set.