SECTION 33: BAGGAGE AREA
Build Instruction Updates
- N/A
Check for more recent updates here
Hints
If you intend to place antennas under the rear seats, it will be handy to have access panels/covers installed. Included is a template for fabricating the doubler plate that will fit between the seat ribs.
RV-10 Rear Seat Access Plate Doubler.pdf
RV-10 Rear Seat Access Cover Plate.pdf
Page 33-3
- The F-1026 Lower Baggage Door Seal Channel needs bending so the two flanges are parallel and fit flush on a surface. Look into the top opening to make sure the rear flange sits flush on the F-1006A bulkhead.
Page 33-5
- Step 1-4 say "Standard Kit" only, but needs completion on quick build kits as well
Page 33-7
- Step 1: The center two nutplates on the rear flange are supposed to be MS21051-L08 (asymmetric, the two rivets are on the same side), however the QB might come with holes and dimples that assume a K1000-08 nutplate. Consider changing the QB to the drawing, otherwise, two additional holes are needed at the F-1006 Bulkhead bottom as the two center holes will not line up with the asymmetric nutplate.
- Step 3: The AN426AD3-4.5 rivets that attach the F-1026 Lower Baggage Door Seal Channel are too short, consider using longer ones. The rivets are hard to buck but you can insert a 5/8" x 1" x 4" (long, slim) tungsten bar with the angled end towards the rivet.