SECTION 38: RUDDER PEDALS & BRAKE SYSTEM
Build Instruction Updates
- 11/15/04 38_10.pdf
Check for more recent updates here
Page 38-8
Step 2
- Before inserting the rudder cable consider adding a rudder cable fairing to your build. Avery makes a suitable fairing and is available from e.g. Aircraft Spruce. Draw lines 1 inch above and below the exit hole.
- It's hard to do all at once. Best to first get just the screw test threaded and backed out. Then capture just the cable with the adel clamp, hold the adel clamp closed with a temporary safety wire or a Hemostat and get the bolt in a few threads deep. Then remove the safety wire or Hemostat and capture and position the cable sleeve. Lastly tighten the bolt.
