3,777
edits
SECTION 32: TAILCONE ATTACHMENT: Difference between revisions
m
→Page 32-5
m (→Page 32-5) |
m (→Page 32-5) |
||
| Line 41: | Line 41: | ||
== Page 32-5 == | == Page 32-5 == | ||
* Step 6 refers to "Page 33-4, Figure 3", correct is "Page 32-4, Figure 3". Also, debur the 6 holes before dimpling as they were recently match drilled. | * If you plan to install the BRS parachute, match drill and attach / rivet the rear attachment external plate at this stage to the bottom of the tailcone. Some of the rivets are common. | ||
*Step 6 refers to "Page 33-4, Figure 3", correct is "Page 32-4, Figure 3". Also, debur the 6 holes before dimpling as they were recently match drilled. | |||
* Step 18, installing two SB625-7 snap bushings: those shipped with the empennage kit, not part of the fuselage kit / fuselage QB kit.<br>Don't install any of the snap bushings yet that carry the rudder cable. You cannot get the rudder cable end fitting through the snap bushings if they are mounted as they need to be squeezed oval to let them through. Install the snap bushings along with the rudder cable install instructions on page 38-8. | * Step 18, installing two SB625-7 snap bushings: those shipped with the empennage kit, not part of the fuselage kit / fuselage QB kit.<br>Don't install any of the snap bushings yet that carry the rudder cable. You cannot get the rudder cable end fitting through the snap bushings if they are mounted as they need to be squeezed oval to let them through. Install the snap bushings along with the rudder cable install instructions on page 38-8. | ||