SECTION 29: FUSE SIDE SKINS

Build Instruction Updates

• 10/05/21 29_10.pdf

Check for more recent updates here

29-11

• See this FB Post on how to keep the skin and clamping block in place while bending.

29-14

• Step 5
  When match drilling from the F-1001B angle into the WD-1002-L / WD-1002-R firewall steel brackets, be aware that it's easy to violate the edge distance in the steel bracket (2 x D, measured from the center of hole). Remedy is to temporarily install a bolt into the engine mount hole to pull the bracket into place and to use a clamp to move the steel bracket to increase edge distance.
  See also FB post 4/17/2022

29-15

• Questions on which holes to dimple? See this FB thread