SECTION 40: FLAP SYSTEM

Build Instruction Updates

• 05/24/2023 40_10.pdf
  Part ES-FA-PA-450-12-5 replaced with ES-FA-PA-270-12-5
• 11/05/2022 40_10.pdf

Check for more recent updates here

Hints

Page 40-3 Bellcrank jig

• The bellcrank jig comes in the wing kit and at this point you may have possibly misplaced it. The measurement from the bottom of the jig to the 1/4 inch hole shown in Figure 2 is 1 & 31/32 inch if you want to make your own.

Page 40-4

• Step 4: See this pdf with 4 templates for the cutout with rounding radiuses applied. Print at 100%. The outer corner dimensions on the printout should be 2.5" * 1.75".

Flap Position Sensor

• The old flap motor (before mid 2022) has no built-in position sensor and needs an external POS-12 sensor. See section Flap_Position_Sensor