SECTION 36: BRAKE LINES

Build Instruction Updates

• N/A

Check for more recent updates here

Hints

Page 36-2

• Step 2 - The hole in the landing gear mount might need to be enlarged a bit to 7/16 to make the elbow fitting go through. Works best with a 7/16 reamer (e.g. $21 at Yardstore).
  The elbow fitting doesn't quite stick out enough to get a wrench on it when torquing the nuts. Consider adding a AN960-716 / NAS1149F0763 washer sneaked in between the bottom skin and the weldment so that the washer sits between the fitting and the weldment on the bottom side.
• Figure 2 - If you have a return fuel line (e.g. SDS electronic injection), the brake line goes into the aft of the 3 holes, not the center hole as illustrated in figure 2.