3,777
edits
SECTION 10: TAILCONE: Difference between revisions
m
→Page 10-5
m (→Page 10-2) |
m (→Page 10-5) |
||
| Line 21: | Line 21: | ||
== Page 10-5 == | == Page 10-5 == | ||
Step 4 - Consider making a jig to make drawing the center line more consistent and efficient. YouTube video: https://youtu.be/yC1kzDO_Gg8?t=590 | * Step 4 - Consider making a jig to make drawing the center line more consistent and efficient. YouTube video: https://youtu.be/yC1kzDO_Gg8?t=590 | ||
When cutting the stiffeners to length, consider making them slightly longer than Vans recommends in the instructions by approx 1/8 inch. If cut too short, you may end up with edge distance issues when match drilling the end rivet holes. The length can then be adjusted if desired after first fit up. | * When cutting the stiffeners to length, consider making them slightly longer than Vans recommends in the instructions by approx 1/8 inch. If cut too short, you may end up with edge distance issues when match drilling the end rivet holes. The length can then be adjusted if desired after first fit up. | ||
* Don't assume the stiffeners are exactly 8 foot long and just measure how much to cut off, measure across the entire length to mark the cut-off line. | |||
== Page 10-13 == | == Page 10-13 == | ||