4
edits
SECTION 10: TAILCONE: Difference between revisions
→Page 10-5
m (→Page 10-15) |
|||
| Line 8: | Line 8: | ||
== Page 10-5 == | == Page 10-5 == | ||
Step 4 - Consider making a jig to make drawing the center line more consistent and efficient. YouTube video: https://youtu.be/yC1kzDO_Gg8?t=590 | Step 4 - Consider making a jig to make drawing the center line more consistent and efficient. YouTube video: https://youtu.be/yC1kzDO_Gg8?t=590 | ||
When cutting the stiffeners to length, consider making them slightly longer than Vans recommends in the instructions by approx 1/8 inch. If cut too short, you may end up with edge distance issues when match drilling the end rivet holes. The length can been then be adjusted if desired after first fit up. | |||
== Page 10-13 == | == Page 10-13 == | ||