214
edits
SECTION 14: WING RIBS: Difference between revisions
m
→Page 14-03
m (→Page 14-02) |
m (→Page 14-03) |
||
| Line 26: | Line 26: | ||
* Step 1: it's easy to make these cuts using a bandsaw | * Step 1: it's easy to make these cuts using a bandsaw | ||
* Step 2: perhaps the easiest way to make these cuts is with an oscillating tool | * Step 2: perhaps the easiest way to make these cuts is with an oscillating tool | ||
* Step 5: the aftmost bottom flange hole of each W-1011-L and W-1025B-R (the little tab) will need to be dimpled in the future. This may be difficult to access once this is riveted together. Consider dimpling these two holes now on each assembly. Most likely this step is deferred to allow future final-drilling for #40 but with modern kits this is already final sized. | |||
* Step 8: Same as the note for Step 5, but the aft-most bottom hole of W-1010-R and W-1025B-L in this case. | |||
== Page 14-04 == | == Page 14-04 == | ||