SECTION 11: EMPENNAGE ATTACH: Difference between revisions

[[File:rodendtool.jpg|500px]]

Step 3: This can be nearly impossible to do without a few tricks. Even then it is best to get at least one helper.

* The brackets on the elevators that you are attaching to in Detail B tend to be a bit too narrow.

Step 4: You can use two clamps per side instead of duct tape.

Step 5: Now this is where you use Detail C from the previous page. Make sure to fill the gaps as much as possible and fully tighten. Make sure the elevators are perfectly even before drilling. You can use flat dental floss to help get the washers in place, and/or Washer Wrenches. It's tough to get two washers in one side without some dental floss.

Again, consider using two clamps per side to line the counterweight with he HS.

Step 3: If you need to remove the VS and HS later before transporting to your hangar, you do not need remove and prime the parts at this stage.

Step 4:  This step details how to mark a template to drill six holes around each end

of the control rod.