Tools needed to wire a Garmin panel

• DMC AFM8 Crimp Tool M22520/2-01 [1]
• K13-1 M22520/2-08 (Positioner for Male and Female normal density pins) [2]
• K42 M22520/2-09 (Positioner for Male high density pins, Garmin does not use Female high density pins on connectors)
• Stripping tool for 16-26 AWG, e.g. "Stripmaster" from Ideal Ind Inc, e.g. at Amazon [3]
• Pin removal tool normal density, e.g. Aiconics USA, M81969/1-02, red
• Pin removal tool high density, e.g. Step N Go, M81969/1-04, green
• Hex Screwdriver 3/32, at least 2 3/4 inches long, e.g. in set of article 5709A38 at https://www.mcmaster.com/
• Crimp tool for coax and car connectors (ground), e.g. [4]
• Coax dies for above tool, e.g. [5]
• Car connector dies for above tool, e.g. [6]
• Solder station, e.g. [7]
• Fine tip for above solder station [8]
• Digital heat gun, e.g. [9]

Material

• Solder sleeves, starter kit, e.g. this kit [10]
• Solder sleeves, additional, e.g. 50 x [11]
• Grounding wires, additional, e.g. [12]
• Garmin suggested highest quality CAN Bus wire, e.g. [13]
• Shield fasteners for Garmin connectors (not included in connector kits, except for remote COM)
  • McMaster 91772A191 SS Screw
  • McMaster 90107A010 SS Washer
  • McMaster 92147A425 SS Split Washer