183
edits
SECTION 27: FIREWALL: Difference between revisions
Pre-cut side angle flanges for section 29.
(Heat box plans and mod) |
(Pre-cut side angle flanges for section 29.) |
||
| Line 14: | Line 14: | ||
* I found that I needed a double-offset back rivet set that wasn't mentioned in the official tool list: https://cleavelandtool.com/products/12-long-double-offset-back-rivet-set | * I found that I needed a double-offset back rivet set that wasn't mentioned in the official tool list: https://cleavelandtool.com/products/12-long-double-offset-back-rivet-set | ||
* You might want 1ft of this (see below): https://www.aircraftspruce.com/catalog/appages/koolmat.php | * You might want 1ft of this (see below): https://www.aircraftspruce.com/catalog/appages/koolmat.php | ||
== PAGE 27-1 == | |||
You may want to trim the flanges of F-1001M Left Side Angle and F-1001D Right Side Angle. The bold text in Section 29, page 29-14 indicates that it is acceptable to do so, but I think it would be a lot easier to do it here. You'll need to be able to match-drill four holes and each end of each Side Angle is in the way of that match drill. | |||
If you want to do this, you'll want to trim the flange (the part that points aft of the firewall) at each end of each part. I'd suggest trimming 3" from each end of each flange. Here is a picture showing what it looked like after I had to trim it later to give you an idea of the shape you'll need to cut out of the flanges. | |||
== PAGE 27-2 == | == PAGE 27-2 == | ||