3,763
edits
SECTION 34: BAGGAGE DOOR: Difference between revisions
m
no edit summary
m (→Hints) |
mNo edit summary |
||
| Line 6: | Line 6: | ||
* [https://www.youtube.com/watch?v=bqsJr1VQ76I Ed's video on how to make the door removable]<br>Note: you will need more hinge pin length than with the stock setup.<br>[[File:411079963 10231975591278338 2712301933896565881 n.jpg|350x350px]] | * [https://www.youtube.com/watch?v=bqsJr1VQ76I Ed's video on how to make the door removable]<br>Note: you will need more hinge pin length than with the stock setup.<br>[[File:411079963 10231975591278338 2712301933896565881 n.jpg|350x350px]] | ||
* If the pins ends seem loose, consider securing them with a safety wire. Thread the safety wire all the way over to the other end of the door and grab them through the door lock hole. Twist the ends and form the wire so it sits flush when pulling the safety wire all the way back towards the hinge. Safety wire the hinge pins.<br>[[File:2023-12-13 20-19-03.jpg|533x533px]]<br>Split hinge pin with safety wires. | * If the pins ends seem loose, consider securing them with a safety wire. Thread the safety wire all the way over to the other end of the door and grab them through the door lock hole. Twist the ends and form the wire so it sits flush when pulling the safety wire all the way back towards the hinge. Safety wire the hinge pins.<br>[[File:2023-12-13 20-19-03.jpg|533x533px]]<br>Split hinge pin with safety wires. | ||
* Allen's solution is a 3D-printed part to secure the hinge pins, see [https://airplane.allanglen.com/2022/07/31/baggage-door-complete/ allenglen.com] [[File:Screen Shot 2023-12-14 at 4.19.49 PM.png|350x350px]] | * Allen's solution is a 3D-printed part to secure the hinge pins, see [https://airplane.allanglen.com/2022/07/31/baggage-door-complete/ allenglen.com]<br>[[File:Screen Shot 2023-12-14 at 4.19.49 PM.png|350x350px]] | ||
==== Page 34-4 ==== | ==== Page 34-4 ==== | ||
| Line 14: | Line 14: | ||
* Step 5 - You may not be able to reach the upper two rivets from the backside. Consider using two CCR-264SS-3-2 pull rivets. The AN470AD4-5 and AN470AD4-7 rivets on top are hard to reach, consider using pull rivets (Note: LP4-3s are not long enough to replace a 4-7) or use full rivets and a 12 inch back rivet set. | * Step 5 - You may not be able to reach the upper two rivets from the backside. Consider using two CCR-264SS-3-2 pull rivets. The AN470AD4-5 and AN470AD4-7 rivets on top are hard to reach, consider using pull rivets (Note: LP4-3s are not long enough to replace a 4-7) or use full rivets and a 12 inch back rivet set. | ||
[[ | [[Category:Hints]] | ||