GHA-15

Garmin GHA-15 Radar Altimeter

Intro

• The Garmin GHA-15 radar altimeter starts reporting altitude somewhere between 300 and 550 ft.
  Note: the 500 ft announcement is GPS altitude based, 300 ft and lower is then radar altimeter based.
• It transmits at 24 GHz with very low power (milliwatts) compared to COM radios and transponders (20 / 150 Watts). 24 GHz is not the controversial frequency that has interference issues with cell towers.
• It needs very little power and the connector accepts 22 AWG wire or thinner (you can transition to a 22 AWG lead wire near the connector if you want to run a thicker wire).

Videos

• RV12 Driver's Installation
• Midwest Panel Builders Video

Threads

• VAF
• FB

Installation Manual

• The G3X Touch installation manual covers the GHA-15.

---

Notepad

Connector
Note: on the rubbery back side of the connector, the printed "1" seems to be closer to the hole to the left of the "1", but pin 1 is to the right of the "1".
The center pin 22 is a bit off-center to the bottom. Together with hole straight below it, they constitute the vertical center axis of the connector. At the two circles above, the center axis splits between 21/15 and 14/1. At the outermost circle below, it runs between 7/8. The 4 holes above 22 are almost in a perfect square pattern.

On the (hard) back-end of the connector, the numbers are printed in a way that the "1" is actually closer to pin "1".

(as seen from the back of the connector where you insert the pins through the silicone seals)

Screw Torque

• 10-32 Stainless steel: 33 in lb

Tools / Parts Needed

• K40 Positioner for DMC Crimper
• The 10-32 mounting screws are included. If you need more, those are MS51958-67, e.g. McMaster part number 91400A833 (pack of 25, same bolts needed for GPS antennas)
• 4 x 10-32 nut plates, e.g. K1000-3 / MS21047L3
• 63/1000 2024T3 doubler, e.g. 4 x 4 inches
  
  Builder made doubler example (Garmin doesn't provide template).
• Optional: USB-B bulkhead debug connector (instead of Garmin pigtail part no 011-01782-00 which is just a coupling, not a bulkhead connector) at Amazon
  Color code: Black: GND (GHA-15 pin 20), Red: +5V (GHA-15 pin 19), White: D- (GHA-15 pin 10), Green: D+ (GHA-15 pin 9)
  The wire will fit through a 1/4 inch snap bushing (before crimping the pins)
  
• Optional: Suitable 10ft USB-C to USB-B laptop cable at Amazon
• Optional: Alodine pen to treat unpainted skin that will end up under the antenna: at Spruce.
  

FCC Report

• FCC Record