3,777
edits
SECTION 10: TAILCONE: Difference between revisions
Jump to navigation
Jump to search
m
→Hints
(→Hints) |
m (→Hints) |
||
| Line 17: | Line 17: | ||
**Follow the instructions in section 38 (page 38-8) on how to install the rudder cables. Install the cables through F-1007, and coil them for later between F-1006 & F-1007. | **Follow the instructions in section 38 (page 38-8) on how to install the rudder cables. Install the cables through F-1007, and coil them for later between F-1006 & F-1007. | ||
** You will need to wire three (or more) systems: | ** You will need to wire three (or more) systems: | ||
*** The tail light -- refer to OP-56 for instructions on how to route the wire to the rudder. | *** The tail light -- refer to OP-56 for instructions on how to route the wire to the rudder. If you have zip-tips (see [[Wing Tips|Wing Tips)]], the tail light is optional. | ||
*** The trim motor and sensor. | *** The trim motor and sensor. | ||
*** A coax for the VOR antenna -- route a 25ft coax with a male BNC connector to the base of the vertical stabilizer. 25 feet of cable allows an unbroken run all the way to the control panel; each connector results in a drop in signal strength, so the minimum should be used. | *** A coax for the VOR antenna -- route a 25ft coax with a male BNC connector to the base of the vertical stabilizer. 25 feet of cable allows an unbroken run all the way to the control panel; each connector results in a drop in signal strength, so the minimum should be used. | ||