25
edits
SECTION 11: EMPENNAGE ATTACH: Difference between revisions
no edit summary
m (→Page 11-9) |
No edit summary |
||
| Line 7: | Line 7: | ||
Tool to screw in the rod end bearings. The outer ring is a cut-off fitting. | Tool to screw in the rod end bearings. The outer ring is a cut-off fitting. | ||
== Page 11-6 == | |||
Step 4: This step details how to mark a template to drill six holes around each end | |||
of the control rod. | |||
Section 39 ("control system"), page 39-4 step 3 has a better method of drilling the rivet holes. | |||
In particular, use a center punch to make sure the drill does not wander, | |||
and use a drill press if you have one for best accuracy. | |||
Rather than cutting up the plans as Vans suggest, take a photocopy and use that. | |||
== Page 11-9 == | == Page 11-9 == | ||
* Step 5: As a starting point, check these drawinging<br>[[File:Elev1.jpg|600px]]<br>[[File:Elev2.jpg|600px]]<br>The centered starting values for the trim cable nut positions are not very good and require painful iterations.<br>Goal is that both tabs go down 35 degrees, are in sync in neutral and the right tab goes up 25 degrees while the left one stays neutral in all up. | * Step 5: As a starting point, check these drawinging<br>[[File:Elev1.jpg|600px]]<br>[[File:Elev2.jpg|600px]]<br>The centered starting values for the trim cable nut positions are not very good and require painful iterations.<br>Goal is that both tabs go down 35 degrees, are in sync in neutral and the right tab goes up 25 degrees while the left one stays neutral in all up. | ||